–11–
E Cover the naked part of rear turn
signal light lead (left) with the
hose.
F Clamp the wire harness and rear
turn signal lead (right).
G Pass the rear turn signal light
lead (right) between the rear
frame and license bracket,
avoiding to be caught.
H Rout the lead by the outside of
the frame so that it does not con-
tact with the tip of the bolt as
shown in the illustration.
CABLE ROUTING
SPEC
I Pass the rear turn signal light
lead (left) between the rear
frame and license bracket,
avoiding to be caught.
J Clamp the rear turn signal light
lead (left). After clamping, point
the surplus part to the inner side.
K Clamp the thermo switch lead
coupler. After clamping, point
the surplus part to the inner side.
L Battery negative lead to be con-
nected with the ground.
M Route the battery negative lead
above the side stand switch lead
and thermo switch lead.
N No special order is set for the
C.D.I. magneto lead (2 leads),
neutral switch lead, starter motor
lead and battery negative lead.
O Clamp the handlebar switch lead
(left) and clutch switch lead.
P Route the thermo switch lead un-
der the cover connector.
Q Route the starter motor lead un-
der the cover connector.
