Perio
d
ic maintenance an
d
a
d
justment
7-11
7
TIP
Skip steps 4–6 if the oil filter element is
not being replaced.
4. Remove the oil filter element cover
by removing the bolts.
5. Remove and replace the oil filter
element and O-ring.
6. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
TIP
Make sure that the O-ring is properly
seated.
7. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11621
In or
d
er to prevent clutch slip-
pa
g
e (since the en
g
ine oil also
lu
b
ricates the clutch),
d
o not
mix any chemical a
dd
itives. Do
not use oils with a
d
iesel speci-
fication of “CD” or oils of a hi
g
h-
1. Bolt
2. Oil filter element cover
1. Oil filter element
2. O-ring
Ti
g
htenin
g
torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Ti
g
htenin
g
torque:
Engine oil drain bolt:
34 Nm (3.4 m·kgf, 25 ft·lbf)
Recommen
d
e
d
en
g
ine oil:
See page 9-1.
Oil quantity:
Oil change:
1.40 L (1.48 US qt, 1.23 Imp.qt)
With oil filter removal:
1.60 L (1.69 US qt, 1.41 Imp.qt)
U1BE26E0.book Page 11 Thursday, June 25, 2015 9:38 AM