Yamaha SR10RE, Руководство оператора

Страница: 24 / 52

22
6. Install the new oil filter by turning the
oil filter by hand until the seal has con-
tacted the oil filter mounting surface;
then tighten the oil filter to 1.7 kg-m
(12 ft-lb).
7. Install the engine oil drain screw
with a new gasket. Tighten the screw
to 1.0 kg-m (7.2 ft-lb).
8. Remove the four torx-head screws
securing the right-side footrest to the
tunnel and the support; then with a
drain pan in position, remove the
drain plug from the oil tank.
746-121A
 NOTE: To aid in draining the oil
from the tank, position a funnel
between the tank and the opening of
the tunnel running board.
9. After the oil has drained completely,
install the drain plug with a new O-
ring and tighten to 2.2 kg-m (16 ft-lb).
10. Pour the recommended engine oil
into the oil tank.
11. Without starting the engine, place
the handlebar emergency stop
switch to the RUN position and the
ignition switch to the ON position.
The Oil Pressure Warning Icon
should illuminate.
 NOTE: If the warning icon does not
illuminate, take the snowmobile to an
authorized Yamaha Snowmobile dealer
for service. If not under warranty, this
service is at the discretion and
expense of the snowmobile owner.
12. If the warning icon illuminates
(from step 11), start the engine. The
warning icon should go out within
five seconds. If it does, proceed to
step 13.
 NOTE: If the warning icon does not
go out, shut the engine off immedi-
ately and repeat step 11; then place
the ignition switch to the ON posi-
tion and repeat step 12. If the warn-
ing icon does not go out, take the
snowmobile to an authorized
Yamaha Snowmobile dealer for ser-
vice. If not under warranty, this ser-
vice is at the discretion and expense
of the snowmobile owner.
13. Shut the engine off; then add oil to
the oil tank until oil is visible half-
way up in the sight glass.

NOTE: If the oil and engine are not
at operating temperature, the oil
level may read too low. Always make
sure the engine is at operating tem-
perature before checking the oil.
14. Install the access plate and torx-head
screws beneath the snowmobile; then
install the hood and access panels.
Coolant Level

NOTE: Use a good quality, ethyl-
ene glycol-based, automotive-type
coolant.
Locate the filler neck located above the
resonator; then remove the coolant cap
from the filler neck. Verify that the coolant
is at the bottom of the tab in the filler neck.
0747-547
Locate the coolant tank above the drive
clutch; then remove the plug from the
coolant tank. Add coolant to the full level
on the tank. Install the plug.
! WARNING
Always check the coolant level with
the engine cold.