Yamaha SPX1000, Руководство по эксплуатации

Страница: 37 / 79

* A bulk dump will only be received by the SPX1000 if its
MEMORY PROTECT function is OFF and the MIDI
channel is the same as that of the transmitting equipment.
Since bulk data from a second SPX1000, for example, is
loaded into the memory location(s) that it was transmitted
from, make sure that those locations do not cantain
important data that will be overwritten.
F.SW MEMORY RCL
The SPX1000 permits memory selection via an optional
Yamaha FC5 footswitch connected to the “INC/DEC”
footswitch jack. The F.SW MEMORY RCL function permits
setting the range of memory location numbers that will be
selected when the footswitch is pressed.
1. Use the UTILITY key to call the F.SW MEMORY RCL
function. The underline cursor should be located under the
first memory number in the range.
2. Use the parameter and keys to enter the first number
in the range.
3. Press the PARAM key to move the cursor to the second
number in the range.
4. Use the parameter and keys to enter the second number
in the range.
34
F.SW MEMORY RCL RANGE 50 TO 60
If, for example, the RANGE parameter is set to “50 TO 60” as
shown in the LCD illustration above, each time the footswitch
is pressed the next highest memory location will be selected
until the last number in the specified range is reached. After
the last number in the specified range, the first (lowest)
number is selected and the process repeated.
F.SW MEMORY RCL RANGE 44 TO 41
Reverse sequences can be programmed by entering the highest
number in the range before the lowest, as shown below.
In this case the selection sequence is: 44 43 42 41
44, etc.