65
English
REMOTE CONTROL FEATURES
A
D
V
ANCED
OPERA
T
ION
You can clear all changes made in each function set, such
as learned functions, macros, renamed source names and
setup manufacturer codes.
1
Press CLEAR by using a ballpoint pen or
similar object.
y
Complete each of the following steps in 30 seconds. Other
wise, the learning mode will be automatically canceled. In
this case, press CLEAR again.
2
Press
k
/
n
to select the clear mode.
L:DVD
(L: name of a component)
Clears all learned functions in the respective
component control area. Press an input selector
button to select the component.
L:AMP
Clears all learned functions for this unit’s control
area.
L:ALL
Clears all learned functions.
M:ALL
Clears all programmed macros.
RNAME
Clears all renamed source names.
FCTRY
Clears all remote functions and returns the remote
to the factory settings.
3
Press and hold CLEAR again for about 3
seconds.
“C:OK” appears in the display window.
“C:NG” appears in the display window if the operation is
unsuccessful. In this case, start over from step 2.
4
Press CLEAR to exit from the clearing mode.
Once you have cleared a learned function or macro
for a button, the button reverts to the factory setting.
“ERROR” appears in the display window under the following
circumstances:
– When a button other than the cursor is pressed.
– When more than one button is pressed at once.
– When MACRO ON/OFF or 10KEY/DSP is switched to
another position.
Memory back-up
If the remote control is without batteries for more than
3 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries, set up the manufacturer code and program
any acquired functions that may have been cleared.
Clearing function sets
Note
CLEAR
CLEAR
Note
CLEAR
00_RX-V2400U_EN.book Page 65 Friday, October 10, 2003 10:54 AM