62
REMOTE CONTROL FEATURES
6
Press and hold the button you want to
program on the other remote control until
“OK” appears in the display window.
• “NG” appears in the display window if programming was
unsuccessful. In this case, start over from step 5.
• This remote control can learn approximately 120 functions.
However depending on the signals learned, “FULL” may
appear in the display before you program 120 functions. In this
case, clear unnecessary programmed functions to make room
for further learning.
7
Repeat steps 5 and 6 to program additional
functions.
8
Press LEARN again to exit from the learning
mode.
• Learning may not be possible in the following cases:
– When the batteries in the remote control for this unit or other
components are weak.
– When the distance between the two remote controls is too
great or too small.
– When the remote control infrared windows are not facing at
the appropriate angle.
– When the remote control is exposed to direct sunlight.
– When the function to be programmed is continuous or
uncommon.
• “ERROR” appears in the display window if you press more than
one button at the same time.
You can change the name that appears in the display
window on the remote control if you want to use the
different name than the factory preset. This is useful when
you have set the input selector to control a different
component.
1
Press an input selector button
to select the
source component you want to rename.
The selected component name appears in the display
window.
2
Press RE-NAME using a
ballpoint pen or similar
object.
3
Press
k
/
n
to select and enter a character.
Pressing
n
changes the character as follows:
A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash).
(Pressing
k
changes the characters in reverse order.)
4
Press
l
/
h
to move the cursor to the next
position.
y
If you want to continue setting up names for other
components, press ENTER and repeat steps 1, 3 and 4.
5
Press RE-NAME again to exit from the
renaming mode.
Notes
Notes
TRANSMIT
RE-NAME
ST
ANDBY
INPUT MODE
SYSTEM
CLEAR
L
EARN
M
A
C
R
O
OFF
O
N
MA
CR
O
PHONO
MUL
T
I CH IN
CD
DV
D
D
VR/VCR2
VCR 1
TITLE
SOURCE
ENTER
DTV
CBL/SA
T
CD-R
MD/T
APE
TUNER
V-
A
U
X
PO
WER
PO
WER
LEARN
Changing source names in the
display window
PHONO
CD
DVD
DVR/VCR2
VCR 1
DTV
CBL/SAT
CD-R
MD/TAPE
TUNER
V-AUX
RE-NAME
ENTER
ENTER
RE-NAME
00_RX-V2400U_EN.book Page 62 Friday, October 10, 2003 10:54 AM
