Yamaha RX-A3060, Руководство пользователя

Страница: 29 / 230

En
29
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Y
When using only one surround back speaker, connect it to the SINGLE jack (L side).
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and
the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent
confusion, connect the black wire to the negative and the other wire to the positive terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the terminal.
4
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, Australia, Brazil and General models only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
1
2
ZONE OUT/PRE OUT
ZONE 2/
F. PRESENCE
ZONE 3/
R. PRESENCE
SPEAKERS
CENTER FRONT SURROUND BACK SURROUND R.PRESENCE
R L R R R L L L
F. PRESENCE
ZONE 2/ZONE 3/BI-AMP ZONE 2/ZONE 3/F.PRESENCE
EXTRA SP1
R
L
SINGLE
PRE OUT
SUBWOOFER
CENTER FRONT SURROUND SUR. BACK
(SINGLE) (FRONT)
(REAR)
EXTRA SP2
1 2
3
4 5
9 9
T
6 7
Y
E R
The unit
(rear)
FR
ONT
-
+
1 1
2 2
4 4
3 3
+ (red)
– (black)
FR
ONT
+
1 1
2 2
Banana plug
(SINGLE
)
PRE OUT
CENTER
SUR.
BACK
SURR
UND
1
2
SURR
OUND B
ACK
L
(REAR
) SUBW
OOFER
(FR
ONT)
Audio pin cable