TO PROGRAM SIGNALS FROM OTHER
REMOTE-CONTROL TRANSMITTERS
Before programming
•
Some learning keys are larger than others, but all
keys are potentially capable of the sarne functions if
so programmed.
Keys should be programmed and used according
to their positional convenience.
•
Use the included seals to indicate the functions for
which learning keys have been programmed.
It is recommended that you first determine the best
and most convenient layout of the keys for the
various functions you plan to program (and attach
the seals accordingly), and then program the keys
correspondingly.
Follow the steps described below to program
signals from other remote-control transmitters to
this unit.
1.
Set the LEARN-NORM switch to the "LEARN"
position.
LEARNED
=
ERR DR
=
RESET
LEARN NORM
©
..
2.
Position this unit and the other remote-control
transmitter head to head.
Other
remote-control
transmitter
About
5
-
10
em
(2
-
4
in.)
This unit
3.
Press the learning key (or programmable preset
learning key) on this unit to which the programming
will be rnade.
*
If the pressed key is unprogrammed, the LEARNED
indicator will flash continuously. If the key is already
programmed, the LEARNED indicator will flash
continuously and, at the sarne time, the ERROR
indicator will illuminate. Then proceed to the next
step if you want to change that instruction already
programmed for the key. If you do not want to
change it, however, press the key to be
programmed next and proceed to the "learning"
operation of that key.
4.
Press the key (on the other remote-control
transmitter) for the function to be programmed.
*
The LEARNED and ERROR indicators will illuminate
continuously while the signals from the other
remote-control transmitter are being received by this
unit Press and hold the key on the other remote
control transmitter until the illumination of these
indicators stops. The LEARNED indicator will
illuminate for about two seconds when the
programming of signals has been successfully
completed.
5.
Repeat steps
3
and
4
until the signals for all
programmings you want to make are successfully
programmed.
6.
After all programming is completed, set the LEARN
NORM switch to the "NORM" position.
LEARNED
=
ERROR
=
RESET
LEARN NORM
©
..
After all programming is completed, try operating this
unit.
Notes
•
Note that the successful programming of signals to
a learning key results in the erasure of previously
programmed signals and their replacement by the
newly programmed signals.
•
In step
4,
If the key on the other remote-control
transmitter is not pressed within
15
seconds after a
learning key is pressed, this unit will automatically
return to the status that was in effect before the
learning key was pressed.
23
