E-
21
ADVANCED OPERATION
English
ADVANCED
OPERATION
4
Press
or
repeatedly until the desired
number of channels is shown on the display.
The display changes as follows.
5
Hold down the PC input selector key until the
following indication appears on the display.
Although no further operation is required, wait a short time
until the computer completes the changes in the settings.
Notes
●
When the number of channels is changed for the first
time, the device driver for the USB audio is installed in
the computer. Wait a short time until the computer
completes the changes in the setting.
●
Do not change the USB channel setting under any
circumstance during playback or recording via the USB
connection on the computer. If changed, the computer
may freeze.
How to set
*
When playback or recording is performed on the
computer via the USB connection, terminate the
playback or recording software used on the computer.
1
Turn on this unit.
2
Press the PC input selector key repeatedly until
“USB” appears on the display.
3
Hold down the PC input selector key until the
current channel setting is shown (for about two
seconds).
* When the display of this unit shows “USB” in red, USB
audio is being played back, disabling this USB channel
setting function. Terminate the software used on the
computer.
Front panel
TUNER
PC
AUX1
AUX2
Front panel
Front panel
Front panel
Front panel
The number of
channels before the
change
The number of
channels after the
change
PC
AUX1
AUX2
TUNER
DSP
P-SET
VOL
VIRTUAL
5.I
CH
DIGITAL
PROLOGIC FM AM ST
USB PCM
D. DSP
4
2, 3, 5
1
TUNER
PC
AUX1
AUX2
TUNER
PC
AUX1
AUX2