E-
29
APPENDIX
English
APPENDIX
Problem
When making a recording from an
audio CD to an MD, CD-R, etc., all
tracks are recorded as one track.
Program sources on an MD, CD-R,
etc. which is a copy of an audio
CD, cannot be recorded on the
computer via the USB connection.
Signals inputted to your computer
via the USB connection cannot be
recorded on the computer.
Different sounds are heard
together.
Using this unit affects TV
reception or the performance of
other equipment.
Left and right volume levels are
different.
The remote control does not work.
The remote control does not
function properly.
Cause
A DSP sound field program is selected or the
built-in graphic equalizer is used.
You cannot make a recording from a CD-R,
MD, etc. which is a copy of an audio CD, to
another CD-R, MD, etc. via the USB
connection or the digital terminal connection.
Incorrect setting of the recording device on the
computer.
Sound from the computer via the USB
connection may be mixed with sound from
other sources because the “USB Mix” setting
is set to “ON” with the Application Software.
The equipment may be too close to this unit.
The level balance is not set to center on the
“Balance” setting on the VIRTUAL panel in the
Application Software.
The batteries of the remote control are weak.
Wrong distance or angle.
Direct sunlight or strong light (of an inverter
type fluorescent lamp etc.) is striking the
remote control sensor of the main unit.
What to Do
Turn off the DSP and the graphic equalizer.
Record the signals of such an MD, CD-R, etc. on
the computer by sending the signals via an
analog connection.
Correctly set the recording device on the
computer. [Refer to “Recording on computer (via
the USB connection”) on page 13.]
Set the “USB Mix” setting to “OFF” if you do not
want to hear mixed sounds.
Move the equipment away from this unit.
Set the level balance to center.
Replace the batteries with new ones.
The remote control will function from a maximum
range of 6 meters and no more than 30 degrees
off-axis from the front panel.
Reposition the main unit.
Problem
Application does not start.
The driver software cannot be
installed successfully.
Cause
This unit and the computer is not connected
with the USB cable.
The power cord is not plugged in or is not
completely inserted.
The USB cable is not firmly connected
between this unit and the computer.
The power cord is not plugged in or is not
completely inserted.
What to Do
Connect this unit and the computer with the
USB cable.
Firmly plug in the power cord.
Disconnect the USB cable, and then connect it
firmly again.
Firmly plug in the power cord.
When installing or using the Application Software
