Setting the CUE Mode
21
ProMix 01 Getting Started Guide
Setting the CUE Mode
For the rest of this tutorial and the next, we’ll use the ST FIX CUE
mode. In this mode, the MONITOR OUT and PHONES signals are
the same as those of the main STEREO OUTPUT.
1. Use the PARAMETER wheel to select ST FIX.
ST FIX flashes.
2. Press [ENTER] to confirm the setting.
The sound is cut and ST FIX appears highlighted. Any channels that
were in the previous CUE MIX are released. The following display
shows the CUE LCD function with the CUE mode set to ST FIX.
Channel 9 is selected.
Setting Fader Levels
To hear our sound source again we need to feed the channel 9 signal
to the main stereo outputs (i.e. the main stereo mix).
1. Set channel 9’s fader to the 0dB mark.
The 0dB fader position is a good place to start when setting fader lev-
els. It’s a good setting with regard to signal level and noise perfor-
mance and it leaves room for you to raise the level later, if necessary.
2. Set the ST OUT fader to the 0dB mark.
You can now hear your sound source and the stereo output meters
are indicating the stereo output level. The stereo mix signal is now
being output to the STEREO OUTs and digital and analog REC
OUTs.
Note that the Peak Hold function, which is set on the METER LCD
function, also works on the stereo output meters.
ꎹ
ꎹ
