PM1D V2 System Software Installation Guide
4
INPUT/OUTPUT UNIT section
CONSOLE section
The system will recover from these limitations when you remove
the cause of the problem and turn on the power of the CS1D
once again.
System update procedure
When updating the system, you must perform the update and
installation for all components. Using the procedure described
below, perform the firmware update and the CS1D screen
software update.
Updating the firmware (CS1D/
DSP1D(-EX)/AI8/AO8/DIO8)
You will use the PM1DLOAD software to update the firmware of
each component. The basic procedure and the update method
for each firmware is explained below.
[Explanation of each screen in PM1DLOAD]
Mode Select screen
A
“Write via serial port” mode
You must select this.
B
“Write board directly” mode
Do not select this.
Main screen
C
[Setup] menu
D
Target select menu
...................specify the component to be
written
E
Overall version
.........................indicates the version to be
written (overall version)
F
Writing target check boxes
......check boxes select writing
target
G
ROM version field
....................indicates the currently-
written version
H
File version field
.......................indicates the version to be
written
I
[GetVer.] button
.......................obtains the ROM version
INPUT UNIT not OK
Only that unit is muted, and will not be
controllable
OUTPUT UNIT not OK
Only that unit is muted, and will not be
controllable
INPUT01-12 not OK
INPUT block (CS1D lower left) inoperable
INPUT13-24 not OK
INPUT block (CS1D upper left) inoperable
INPUT25-36 not OK
INPUT block (CS1D lower right) inoperable
INPUT37-48 not OK
INPUT block (CS1D upper right) inoperable
INSEL not OK
SELECTED INPUT CHANNEL block
inoperable
MAS1 not OK
MIX OUTPUT / DCA GROUP block inoperable
MAS2 not OK
MIX OUTPUT / DCA GROUP block inoperable
OUTSEL not OK
SELECTED OUTPUT CHANNEL block,
SCENE MEMORY block, MASTER block, LCD
FUNCTION ACCESS block, USER DEFINE
block, STEREO OUTPUT block, Data entry
block (except for track pad and left/right
switches) inoperable
METER not OK
METER BRIDGE block will not function
NOTE:
•
These problems can normally be solved by executing the system
update described below. However, if problems remain after this is
done, please contact Yamaha service.
•
If there is a problem with a unit, please check whether there is a
faulty connection for the D-Sub half-pitch 68-pin cable. The unit
will not function correctly if a pin is bent or not inserted.
Scene data etc. that you created using this system must be
backed up on a memory card before you perform the update.
The internal data will be lost when you perform the update
procedure.
For details on how to save data to a memory card, refer to
the Reference Manual (Software).
Serial Port
select the computer’s serial port (only ports
1–9 are supported) to use
Connection Point
select the serial port (only ports 1–9 are
supported) to use on the PM1D system
Fonts
change the display font
2
1
4
6
5
9
J
K
L
7
3
8
