Deutsc
h
Français
Español
English
E-
5
CONNECTIONS
• Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the
amplifier (or receiver) with the provided speaker cables.
• Connect the (+) terminals on the amplifier (or receiver) and speakers using the one side of cable. Connect the
(–) terminals on both components using the other side of the cable.
How to connect
1
Loosen the knob.
2
Insert the bare wire.
Remove the insulation
coating at the extremity of each speaker cable
by twisting the coating off.
3
Tighten the knob and secure the cable.
Test the firmness of the connection by pulling
lightly on the cable at the terminal.
When using a banana plug
1
Remove the cover by pulling it toward you.
2
Tighten the terminal knob.
3
Insert the banana plug into the terminal.
The front cover is fastened to the enclosure at four
points and can be removed if desired.To remove the
cover, hold on to both sides and slowly pull straight
away from the speaker. To reattach, line up the four
holes on the inner surface of the cover with the four
corresponding pegs on the speaker and push gently.
Note:
When the cover is removed, be sure not to touch
the speaker units with your hands or to exert
excessive force with any tools.
Notes:
• Make sure that the bare wires are not touching each other as this could damage the speaker and amplifier.
• Connect one speaker to the left terminals of your amplifier, and another speaker to the right terminals,
making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
Loosen
Tighten
Red (+)
Black (–)
(–)
(+)
3
3
3
3
1
1
1
1
2
2
2
2
Banana
plug
3
2
1
REMOVING THE FRONT COVER
