7
ME02R96
ENGLISH
Install the ME02R96 Expansion Board and the Battery
1.
Disconnect the 2 flat cables from the connectors
on the CPU board.
The cables are connected to white connectors.
Before disconnecting each cable, pull the con-
nector latch up as shown in the illustration.
2.
Remove the 4 screws holding the CPU board in place, and remove the CPU board.
3.
Mount the ME02R96 board.
Connect the two black connectors on the underside of the ME02R96 board to the two black
connectors on the 02R96. Then fasten the ME02R96 into place using 4 screws (the 4 screws
you removed above, or the 4 screws included in the kit).
4.
Reconnect the 2 flat cables.
To reconnect: Push the latch down, then insert the cable so that the red line on the cable is
aligned with the
▼
mark on the board.
5.
Install the supplied lithium battery. This is a backup battery that is required to maintain data in
the 02R96 unit’s expanded memory.
When installing the expansion board, you can use either these 4 screws or else the 4 screws included
in the kit. If you reuse these original screws, you will not need the screws in the kit.
CPU
<Top View>
4 Screws
Lithium Battery
Flat Cable
Latch
