3
ME02R96
ENGLISH
●
Note About Versions and Upgrades
System software:
The ME02R96 includes system version 1.20 or higher, and is not compatible with pre-V1.20 soft-
ware. Before upgrading your 02R96 again in the future, be sure that your updater program is V1.20
or higher.
Studio Manager:
The ME02R96 is not compatible with Studio Manager versions prior to V1.1.1. If your version is
older than V1.1.1, please replace it by installing the Studio Manager version included on the accom-
panying CD-ROM. For information about how to carry out the installation, refer to Studio Manager’s
installation guide.
Note that Macintosh system requirements are now as indicated in the table below.
Macintosh System Requirements
For the latest information about System software and Studio Manager, please visit our website at:
www.yamahaproaudio.com.
●
Save the Data from the 02R96
1.
Press the DISPLAY ACCESS [MIDI] key to open the Bulk Dump page.
2.
Set CATEGORY to ALL, select the TRANSMIT button, and then press the [ENTER] key to
start the save.
Computer
A Macintosh G3/233 MHz or better and a USB port
OS
Mac OS 8.6 to 9.2.2 (Mac OS X not supported)
Memory
120 MB or more of free memory (Virtual memory must be turned off)
Hard Disk
7 MB or more
Display
1024
×
768 pixels, 256 colors or higher
1280
×
1024, 32,000 colors recommended
Other
OMS 2.3.3 or later
Note: If you are using a PowerBook on battery power, open the Energy Save
control panel, and in Advanced Settings, Additional Power Savings, turn off
Allow processor cycling.
The board installation procedure will clear all 02R96 user memory, and will reset all 02R96 settings to
their defaults. Before starting installation, use the following procedure to save the data from the 02R96
into an external MIDI device. You can then restore the data after completing the installation.
As an alternative, you can use Studio Manager to save the 02R96 data into a computer. For details,
refer to the Studio Manager owner’s manual (PDF file).
