Yamaha FZ-16, Руководство по обслуживанию

Страница: 112 / 267

HANDLE
1
to
4.
Assembly:
•
Brake light switch front "1"
NOTE:
6.
Assembly:
•
Clutch cable
NOTE: Align the projection "a" in the handlebar switch
left with the hole "b" on the handlebars.
Lubricate the clutch cable end with
a thin layer of grease lithium soap base.
to
1
b
5.
Assembly:
•
Left handlebar "1"
•
Handlebar cap "1"
a. Apply a thin layer of rubber adhesive
at the left end of the handlebar.
b.
Slide the handlebar grip in the
left end of the handlebar.
c.
Wipe off any excess rubber adhesive
with a clean cloth.
WARNING
7.
Assembly:
•
Brake master cylinder
•
Clamp the brake master cylinder
See the "BRAKE
FRONT "on page 4-23.
8.
Assembly:
• l
Throttle grip "1"
•
The throttle cable "2"
•
The right handlebar switch "3"
•
Plug the handlebar
NOTE:
•
Lubricate the throttle cable end and
Inside the throttle grip with
a thin layer of soap-based grease
lithium and then install the handlebar grip.
•
Guide the throttle cable through the slot
on the right handlebar switch, then
install the cable.
•
Align the projection of "a" in the switch
right handlebar with the hole "b" in the
handlebar.
•
Must be of 1-3 mm of clearance "c" between the
handlebar handle and the end of handlebar
Do not touch the handlebar grip until
rubber adhesive has dried completely.
NOTE:
Should be less than 3 mm of clearance "a"
between the grip of the handlebar and the end
Handlebar
4-33