Yamaha FJR 1300 AE 2014, Руководство по обслуживанию

Страница: 626 / 694

ELECTRONICALLY ADJUSTABLE SUSPENSION SYSTEM
8-175
TIP
If a fault code number other than fault code No. 50 is displayed, repair the malfunction for that fault code
number first.
Meter display
When completed successfully:
“00” is displayed in the multi-function meter right display and the
electronically adjustable suspension system warning light goes off.
The preload is adjusted to the solo-riding position.
When not completed successfully:
“F0” is displayed in the multi-function meter right display and the
electronically adjustable suspension system warning light remains
on. Remove the rear shock absorber assembly DC motor and ad-
just it by hand.
After adjusting the DC motor, perform the procedure for diagnostic
code No. 84 again. If “F0” is displayed again, replace the rear
shock absorber assembly.
Procedure
To adjust the preload home position, simultaneously press the
“TCS” button and “RESET” button for 2 seconds.
Item
Probable cause of mal-
function and check
Maintenance job
Confirmation of service
completion
1 Malfunction in SCU. Replace the SCU. Execute the diagnostic mode
(code No. 84). Service is fin-
ished.
Fault code No. 89
Item
Signals cannot be transmitted between the SCU and the ECU
and between the SCU and the meter assembly. (Fault code No.
89 is displayed in the multi-function meter right display only
when abnormal ECU communication is detected.)
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. —
Meter display —
Procedure —
Item
Probable cause of mal-
function and check
Maintenance job
Confirmation of service
completion
1 Connection of ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins). Improperly connected
→
Connect the coupler secure-
ly or replace the wire har-
ness.
Turn the main switch to “ON”.
Fault code number is not dis-
played
→
Service is finished.
Fault code number is dis-
played
→
Go to item 2.
Fault code No. 50
Item SCU (suspension control unit): open or short circuit detected.