Yamaha Fazer, Руководство по обслуживанию

Страница: 100 / 213

ENG
ENGINE INSPECTION AND REPAIR
4-26
PRIMARY DRIVE GEAR INSPECTION
1. Inspect :
• Primary Drive Gear teeth ¿
• Primary Driven Gear teeth À
Wear/damage Ÿ Replace both Gears as
a set.
NOTE :
Refer the general specification for grading.
Excessive noise during operation Ÿ Replace
both Gears as a set.
CLUTCH INSPECTION
1. Inspect :
• Friction Plates
Wear/damage Ÿ Replace the Friction
Plates as a set
2. Measure :
• Friction Plate thickness ç using a Vernier
Calliper at four points.
Out of specification Ÿ Replace the
Friction Plates as a set
3. Inspect :
• Clutch Plates for damage
• Clutch Plate Warpage Using a Surface
Plate and a Feeler Gauge ¿
Out of specification Ÿ Replace the Clutch
Plates as a set
Thickness (Friction Plate) :
3.0 ~ 3.1 mm
<Limit>: <2.8 mm>
Warp limit (Clutch Plate ):
Less than 0.05 mm
BALANCER WEIGHT INSPECTION
1. Inspect:
• Balancer drive gear teeth ¿
• Balancer driven gear teeth À
Wear/damage Ÿ Replace as a set
2. Inspect:
• Balancer Shaft
• Wear/bend/damageŸ Replace
¿
À
¿