Operation
64
3.
Slightly tilt the outboard motor up to the
desired position and push the tilt lock le-
ver down to the lock position.
4.
To return the outboard motor to the nor-
mal running position, pull the tilt lock lever
up to the release position and slowly tilt
the outboard motor down.
5.
Push the tilt lock lever down to the lock
position.
EMU32851
Power trim and tilt models
The outboard motor can be tilted up partially
to allow operation in shallow water.
NOTICE
ECM00260
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32913
Procedure for power trim and tilt models
1.
Place the remote control lever / gear shift
lever in neutral.
2.
Slightly tilt the outboard motor up to the
desired position using the power trim and
tilt switch.
WARNING! Using the power
trim and tilt switch on the bottom
cowling while the boat is moving or
engine is on could increase the risk of
falling overboard and could distract
the operator, increasing the risk of
collision with another boat or an ob-
stacle.
[EWM01850]
U6D779E0.book Page 64 Tuesday, November 15, 2011 2:33 PM
