Yamaha F25G, Руководство пользователя

Страница: 57 / 108

Operation
51
engine will not start after 5 seconds
of cranking, return the main switch to
“
” (on), wait 10 seconds, then
crank the engine again.
[ECM00193]
TIP:

When the engine is cold, it needs to be
warmed up. For further information, see
page 51.

If the engine is warm and fails to start,
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 89.
EMU36511
Checks after starting engine
EMU36524
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
ECM01811
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check wheth-
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
EMU27671
Warming up engine
EMU27718
Manual start and electric start
models
(1) After starting the engine, allow it to idle
for 3 minutes to warm up. NOTICE: Fail-
ure to do so will shorten engine life.
[ECM04550]
(2) Be sure the low oil pressure-alert indica-
tor goes off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine
starts, stop the engine. Otherwise,
serious engine damage could occur.
Check the oil level and add engine oil
if necessary. Consult your Yamaha
dealer if the cause for the low oil
pressure alert cannot be found.
[ECM01832]
ZMU08761
6FM-28199-75-1E0.book 51 ページ ２０１９年１０月３０日 水曜日 午前１１時２３分