Operation
53
EMU36463
Controls
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
Look for loose or damaged connections of
the throttle and shift cables.
EMU36484
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU37054
Engine oil
1.
Put the outboard motor in an upright po-
sition (not tilted).
NOTICE:
If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01791]
2.
Remove oil dipstick and wipe it clean.
3.
Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
4.
Check the oil level using the dipstick to
be sure the level falls between the upper
level mark and lower level mark. Consult
your Yamaha dealer if the oil level is out
of specified level or if it appears milky or
dirty.
EMU27154
Engine
Check the engine and engine mounting.
Look for loose or damaged fasteners.
Check the propeller for damage.
Check for engine oil leaks.
EMU36494
Flushing device
Check that the flushing device’s garden hose
connector is securely screwed on to the fit-
ting on the bottom cowling.
NOTICE:
If the
garden hose connector is not properly
1. Clip
2. Engine shut-off cord (lanyard)
ZMU06873
1
2
1. Oil dipstick
1. Oil dipstick
2. Lower mark
3. Upper mark
ZMU06221
1
1
3
2
ZMU07056
U63P3FE0.book Page 53 Thursday, December 5, 2013 10:01 AM
©
2019 Yamaha Motor Corporation, U.S.A.
