Yamaha Electone EL-37, Руководство пользователя

Страница: 54 / 108

52
6. Music Disk Recorder
6.
After numbers appear on the LED
display of the M.D.R., begin playing.
Once the setup operation in step #5 is complete, a number will
appear on the LED display indicating that you can begin
recording your performance. The number also indicates the
amount of memory left on the disk.
If you make a mistake during recording:
1) Press the PLAY button while the M.D.R. is still
running.
This stops the recording and returns you to the starting point of
the song.
The letters "rE" (retry) appear on the left side of the LED
display and the PLAY and CUSTOM PLAY LEDs start flashing,
indicating that you can re-record the song.
2) Press PLAY again to begin re-recording the song.
Re-recording starts from the beginning of the song and replaces
the previously recorded performance with the newly recorded
performance.
7.
When you finish playing, press the STOP
button.
When the STOP button is pressed, both the RECORD and PLAY
lamps go out, and recording is stopped.
8.
To hear your newly recorded
performance, press the PLAY button.
Playback will begin after a couple of seconds. For more
information on playback and other playback-related functions,
see page 58.
PAUSE STOP PLAY SONG SELECT RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL CONTROL
CUSTOM PLAY
SHIFT
RECORD PLAY
FORMAT
SONG
REPEAT
FROM SONG DEL.
SONG COPY
TO
MUSIC DISK RECORDER
TEMPO + –
6 2 2
PAUSE STOP PLAY SONG SELECT RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL CONTROL
CUSTOM PLAY
SHIFT
RECORD PLAY
FORMAT
SONG
REPEAT
FROM SONG DEL.
SONG COPY
TO
MUSIC DISK RECORDER
TEMPO + –
The short time it takes to set up for recording is
recorded as well, causing a short pause before
playback of the song.
NOTE
PAUSE STOP PLAY SONG SELECT RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER PEDAL CONTROL
CUSTOM PLAY
SHIFT
RECORD PLAY
FORMAT
SONG
REPEAT
FROM SONG DEL.
SONG COPY
TO
MUSIC DISK RECORDER
TEMPO + –
0 1
Be sure to remove the floppy disk from the disk
drive after the STOP lamp lights up and the LED
below the disk slot goes out.
When the available memory reaches "008" or less, the
numbers begin flashing to warn you. If this happens,
stop recording before the display reaches "000."
NOTE
Never attempt to press the eject button or turn the
power off during recording, reading and playing
back. Doing so can damage the disk and possibly
the disk drive. Be sure to remove the floppy disk from the
disk drive before turning off the power.