E-
23
LISTENING TO VIDEO SOURCES
1.
Press the INPUT button to select “VIDEO 1” or “VIDEO 2”.
2.
Follow the instructions supplied with the VCR or other video equipment.
LISTENING TO THE RADIO
To turn the unit on and listen to the last received station, press the
TUNER button on the remote control.
Automatic/Manual tuning
1.
Press the INPUT or TUNER button to select FM or AM.
When using the remote control, press the TUNER button instead
of the INPUT button.
2.
Automatic tuning
Press the or TUNING – button for at least 1 second to tune
in a station. The unit will scan up or down the band and receive the next
receivable station. Press the button again to continue.
Manual tuning
Press the or TUNING – button briefly until the desired
frequency is displayed.
To preset stations
Up to 20 FM and 10 AM stations can be preset.
Automatic presetting (APT)
1.
Press the INPUT or TUNER button to select FM or AM.
2.
Press the MEMORY button for at least 3 seconds. “PROG.” flashes.
The automatic tuning mode is set and automatic presetting begins
from the low end of the band.
When 20 FM or 10 AM stations have been preset or the high end of
the band is reached, automatic presetting stops. “PROG.” disappears
and the station memorized on channel 1 will be heard.
3.
To preset stations on the other band, follow steps above.
Note:
If APT is activated, all previously programmed stations of the band will be
cleared and new stations will be programmed.
Manual presetting
1.
Tune in the station to be preset as described in “Automatic/Manual
tuning”.
2.
Press the MEMORY button.
3.
While “PROG.” is flashing, press the PRESET button to select the
channel to be preset.
4.
While “PROG.” is flashing, press the MEMORY button.
-
In this example, “90.1 MHz” FM station is preset on FM channel
9.
5.
Repeat steps above to add more preset stations.
-
When presetting a new station, the previous preset station is cleared.
Listening to preset stations
1.
Press the INPUT or TUNER button to select FM or AM.
2.
Press the PRESET button briefly to select the desired channel.
-
The number buttons on the remote control can also be used.
Example: Press 0, then 9.
Preset scan tuning
1.
Press the INPUT or TUNER button to select FM or AM.
2.
Press the PRESET button for at least 1 second. The channel number
appears. Each of the preset stations is tuned in for 5 seconds.
-
The PRESET button on the remote control can also be used.
3.
When the desired station has been tuned in, press the PRESET
button again to keep the reception locked at that station.
To receive FM stereo broadcasts
Make sure that “MONO” is not displayed. If “MONO” appears, press the
FM MODE button to turn the “MONO” indication off.
“ST” appears when an FM stereo broadcast is received.
-
If the signal from an FM stereo station is weak and reception is poor,
press the FM MODE button to change to the MONO mode. The
reception may be improved, but the sound will be monaural.
MHz
PROG.
MHz
PROG.
MHz
MHz
(U.S.A. and Canada models)
(U.S.A. and Canada models)
(U.S.A. and Canada models)
(U.S.A. and Canada models)
A3-60U-E (02.7.26)a
02.8.8, 3:39 PM
23
