Yamaha DTX RS10-HXR, Руководство пользователя

Страница: 7 / 12

7
RS10-HXR Owner’s Manual
3.
Adjust the overall balance of the rack stand using the illustration as a reference.
To rotate the curved pipes (
e
,
o
), loosen both fixing bolts
t
on the open clamps
r
and fixing bolts
!0
on the memory clamps
u
, and then rotate the parts simultaneously. After determining the position,
tighten the fixing bolts
t
and
!0
to secure.
4.
A bubble level is incorporated into the logo clip
!1
in the middle of the curved pipe assembly (L)
e
.
Adjust the height on the left and right sides of the curved pipe so that the bubble (on the built-in bubble
level) comes to rest in the middle of the circle (Fig. B-a) (so that the curved pipe is level with the floor).
The logo clip
!1
is removable so it can be used to adjust the other curved pipe (R)
o
.
5.
Attach the drum trigger module arm
!2
to the leg assembly (R)
i
and secure.
Loosen both fixing bolts
!4
and
!5
on the open clamp
!3
, and then insert the clamp to the leg assembly
(R)
i
. After determining the position, tighten the fixing bolts
!4
and
!5
to secure.
6.
Leg bases (
!6
,
!7
,
!8
) can be rotated, or their lengths adjusted if necessary.
7.
Check for loose screws and tighten all screws.
NOTE
Secure the assembly so that the two parts holding the leg assemblies are parallel.
CAUTION
Make sure to tighten the bolts regularly. Failure to do so might result in damage to the product or even injury.
When some of the legs do not touch the floor
1. Loosen the lower open clamp on the leg assembly (C), and then remove the assembled curved pipe assembly (R),
leg assembly (R) and drum trigger module arm.
2. Slightly loosen the open clamps and memory clamps attached to both ends of the curved pipe assembly (L), adjust
the height on the left and right side of the curved pipe assembly (L) so that the bubble (on the built-in bubble level)
comes to rest in the middle of the circle, and then secure the open clamps and memory clamps again.
3. Attach the assembled curved pipe assembly (R), leg assembly (R) and drum trigger module arm.
4. Slightly loosen the open clamps and memory clamps attached to both ends of the curved pipe assembly (R),
adjust the height on the left and right side of the curved pipe assembly (R) so that the bubble (on the built-in bubble
level) comes to rest in the middle of the circle, and then secure the open clamps and memory clamps again.
CAUTION
Be sure to proceed slowly when loosening open clamps and memory clamps to prevent the curved pipe assembly
from falling.
Your electronic drum rack is now ready. For instructions on assembling the pads and the drum trig-
ger module, refer to the Assembly Manual that came with the pad set package.