46
T
ROUBLESHOOTING
The disc can not be erased because the
Index Picture Screen does not appear
Open the tray while leaving the disc in.
Press and hold
CLEAR
for about five seconds until the tray closes. The disc
is technically not yet erased but you can start a new recording like on a blank
disc.
The Index Picture Screen does not appear
but the titles on the disc still a play period
Take out the disc. Clean the disc. Insert the disc.
If available choose ‘Adapt disc format’ (see
A DVD player shows the Index Picture
Screen but does not react to the
2
Press
9
to exit the Index Picture Screen, then press
2
.
A DVD+RW disc does not play on a certain
DVD player
• There are DVD Players that will not play recordings made with a DVD
Recorder. With a special procedure the recorder will solve this problem
for some players. Proceed as follows:
1. Put the disc in the drawer (do not close the tray).
2. Press and hold the
2
key on the remote control for several seconds until
the tray closes. The disc is now modified.
3. If the change has no effect, you may perform the same procedure with the
3
key on the remote control.
Note:
Modifying the disc can solve the problem for a specific player model, but playback
in other DVD players may no longer be possible.
It is therefore recommended to use this procedure carefully and only when needed.
• To revert the disc to the original state, follow the same procedure with the
1
key on the remote control.
Note:
To achieve maximum compatibility, make sure the disc contains at least 5 minutes
recorded in HQ mode, 12 minutes in SP+, 20 minutes in EP or 30 minutes in EP+
mode. For more information about compatibility with DVD players refer to
‘Troubleshooting’ in the instructions for Use.
Symptom
Remedy
