Parameter Edit Mode - 17
D5000
When the D5000 is in standby mode, the bar graph at the bottom of the LCD will have the message
"
REC. READY
" displayed on it. During the recording process, the bar graph indicates the current
status. Upon completion of the recording, the message "
OK
" will be displayed on the bar graph.
AUTO
Press the
[ TRIGGER ]
key or step on a footswitch
connected to the TRIGGER Footswitch Jack to put
the D5000 in standby mode. Recording will start
automatically when the input signal is higher than
the specified threshold.
MODE
(
RECORD
/
OVERDUB
/
CAPTURE
)
Select a recording mode.
RECORD
Create a new recording.
OVERDUB
Combine the new recording with existing data.
CAPTURE
The most recent input signal will be recorded for
the maximum recording time (see below).
TRG.DLY
(-1000 ~ +1000 ms)
Set the delay between triggering and the actual recording. This
parameter is only effective with the
AUTO
recording method. The
default value is
TRG.DLY
= 0 which means recording begins
simultaneously with the trigger. If a negative value is specified,
sound sampled before the trigger occurs is also stored.
NOTE
If the recording mode is set to
OVERDUB
, the standby message will be "
OVER DUB READY
". If you
change the
TRACK
from
STEREO
to
L-MONO
(or the opposite) after recording, it is not possible to
overdub on the existing data.
If you select the CAPTURE recording mode, the D5000 begins recording
as soon as you press the
[ TRIGGER ]
key or step on a footswitch connected
to the TRIGGER Footswitch Jack. You cannot stop the recording until it
has recorded the default amount (5.2 seconds in stereo or 10.4 seconds in
mono) and the bar graph display has stopped moving. Recording will
continue until you press the
[ TRIGGER ]
key or step on the footswitch
again.
Trigger
Level
Not recorded
Input Signal
TRG.DLY = 0
Not recorded
Start the recording
by trigger
Input Signal
TRG.DLY = 0
Input Signal
Trigger
Level
Also recorded
Start the recording
by trigger
TRG.DLY < 0
TRG.DLY
