PERIODIC MAINTENANCE AND ADJUSTMENT
6-19
6
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals and
that the breather hose is properly
routed, in good condition, and not
obstructed.
NOTICE:
If the
breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas ex-
pelled from the battery, the
frame could suffer structural
and external damages.
[ECA10601]
EAU23503
Replacing the fuse
The fuse holder is located behind panel
B. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “
” and turn off all
electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
3. Turn the key to “
” and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
1. Battery
2. Fuse
1
2
1
2
ZAUM0570
Specified fuse:
7.5 A
U2DWE0E0.book Page 19 Thursday, December 20, 2012 6:07 PM