Yamaha CS1D, Руководство по обслуживанию

Страница: 112 / 150

1. Install and set PM1DLOAD with the methods above.
2. Connect a D-sub 9-pin serial cable (cross) and DSP-CHECK (serial communications jig) between the PC and the connector for
the sheet to be written as in the figure above. (For the sheet names and connector numbers, see Page 103.)
3. Switch on the power for CS1D.
4. After PM1DLOAD starts up, select CardDirect with MODE SELECT, then press OK.
Use the setup menu to set the serial port. (The connection port is ignored and remains as is.)
5. Press the Update button in the CS1D item.
6. Select the name of the desired firmware, then press Write.
(See Page 103.)
7. Check that immediately after the Write button is pressed, the red LED on each board stays lit up. (*1)
8. After writing ends, end PM1DLOAD.
9. Switch off CS1D and remove the PH connector, then switch the power for CS1D on again and check that it starts up normally.
(*1) If the LEDs are not staying on, add the procedure below.
[Method for changing to the write ready state manually (other than for PNL, CNL, C_HIF, C_TCU, CMU)]
A) Short Pins 1 and 3 for the target CPU.
B) With the CPU still shorted, switch on the power for CS1D.
C) Check that the red LED on the target board goes On - Momentarily off - Staying on.
D) Continue from 5. above.
• CS1D Screen software installation
It is also necessary to download the program into the CF (compact flash) card in the CPU card (V476140). For the program to use,
the version used, the installation method, etc., refer to the reference below. (However, only for factory settings.)
Please install with the following special card, and when other, install with a commercial card on instruction manual for CS1D.
• Method for extracting software for production and customer service.
Method for extracting software for production and customer service.
Of the files required for inspection, only those files that are necessary for production and customer service are compiled in a software
group for production and customer service in the "PM1D SYSTEM SOFTWARE." These are in a self-extracting file format with a
matching password. Therefore, the following method is required for extracting them.
1. Open the factory folder in the PM1D SYSTEM SOFTWARE.
2. Double clip Factory.exe found in the factory folder.
3. You will be requested to designate the extract folder. Indicate the location to be extracted.
(Example : C:¥Windows¥Desktop¥)
4. You will be prompted for the password. Enter the password provided on the write-completed CD-R assembly
(Drawing number: 3JL-XY714A0).
5. A factory folder will be created in the location designated in Step 3. Open it.
6. ince there will be folders created for each inspection software as shown in the write-completed CD-R assembly,
read the readme.txt for each folder and install and execute each inspection software. .
CS1D
105
Master data to use: Cart for CS1D loader for shipments to factories.
Version used: Ver. 1.00
* Only required for factory settings.
Firmware used: CS1D screen software in PM1D system software
Version used:
Files composed using a PM1D SYSTEM SOFTWARE with a version later than the version shown on
the cover. (Managed with the already drawn CD-R assembly drawing (3JL-XY714A0.)
* The installation method is the same. Refer to install.txt in the PM1D system software.