PERIODIC MAINTENANCE AND ADJUSTMENT
7-12
7
TIP
_
When only changing the engine oil, re-
move drain bolt A. When changing the
engine oil and cleaning the engine oil
strainer, remove drain bolt B also.
_
4. Clean the engine oil strainer with
solvent, and then check it for
damage and replace it if neces-
sary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the engine oil strainer,
compression spring, O-ring and
engine oil drain bolt, and then
tighten the drain bolt to the speci-
fied torque.
TIP
_
Make sure that the O-ring is properly
seated.
_
7. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
_
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
_
ECA11620
NOTICE
_
●
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of “CD” or oils of a
higher quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
●
Make sure that no foreign mate-
rial enters the crankcase.
_
8. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the en-
gine off and check for the cause.
9. Turn the engine off, and then
check the oil level and correct it if
necessary.
1. Engine oil strainer
2. Compression spring
3. O-ring
ZAUU0056
Tightening torque:
Engine oil drain bolt A:
22 Nm (2.2 m·kgf, 16 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 15 ft·lbf)
Recommended engine oil:
Engine oil brand:
YAMALUBE
Engine oil type:
See page 9-1.
Oil quantity:
0.8 L (0.85 US qt, 0.70 Imp.qt)
1PNF8199E0.book Page 12 Friday, August 24, 2012 2:00 PM
