PERIODIC MAINTENANCE AND ADJUSTMENT
7-33
1
2
3
4
5
6
7
8
9
10
11
12
6. Loosen the axle nut.
7. Lift the front wheel off the ground
according to the procedure in the
previous section “Supporting the
motorcycle”.
8. Remove the axle nut, pull the
wheel axle out, and then remove
the wheel.
To install the front wheel
1. Install the brake shoe plate into the
wheel hub as shown.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
3. Insert the wheel axle from the right
hand side, and then install the axle
nut.
4. Lower the front wheel so that it is
on the ground.
5. Connect the brake cable at the
brake shoe plate and then at the
handlebar lever holder.
6. Connect the speedometer cable
and install the clip.
7. Tighten the axle nut to the speci-
fied torque.
8. Adjust the brake lever free play.
9. Slide the rubber cover back to its
original position.
1. Brake shoe plate
2. Slot
3. Retainer
Tightening torque:
Axle nut:
39 Nm (3.9 m·kgf, 28 ft·lbf)
3
1
2
U53C23E0.book 33 ページ ２０１４年１月２２日 水曜日 午後２時７分
