Trouble Recovery
72
the engine is running.
●
Do not touch the ignition coil, spark
plug wire, spark plug cap, or other elec-
trical components when starting or op-
erating the motor. You could get an
electrical shock.
EMU29574
Emergency starting engine
1. Remove the top cowling.
2. Disconnect the start-in-gear protection
cable from the starter, if equipped.
3. Remove the starter/flywheel cover after
removing the bolt(s).
4. Prepare the engine for starting. For fur-
ther information, see page 38. Be sure
the engine is in neutral and that the clip
is attached to the engine shut-off switch.
The main switch must be “
” (on), if
equipped.
5. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope several turns
around the flywheel clockwise.
6. Pull the rope slowly until resistance is
felt.
7. Give a strong pull straight out to crank
and start the engine. Repeat if neces-
sary.
TIP:
When the engine does not start with this pro-
ZMU03891
ZMU02334
ON START
OFF
ZMU01906
ZMU03892
6H1-9-2A-1E0.book 72 ページ ２０１０年２月１７日 水曜日 午前１０時４２分
