Operation
41
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, return the main switch to
“
” (on), wait 10 seconds, then
crank the engine again.
[ECM00192]
TIP:
●
When the engine is cold, it needs to be
warmed up. For further information, see
page 41.
●
If the engine is warm and fails to start,
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 67.
EMU36510
Checks after starting engine
EMU36522
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
NOTICE
ECM01810
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check wheth-
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
EMU27670
Warming up engine
EMU27704
Electric start and prime start models
After starting the engine, allow it to idle for 3
minutes to warm up. Failure to do so will
shorten engine life.
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36980
Stop switches
●
Turn the main switch to “
”, or press the
engine stop button and make sure the en-
gine stops.
●
Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
●
Confirm that the engine cannot be started
with the clip removed from the engine
shut-off switch.
EMU33492
Shifting
WARNING
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ZMU03391
6H1-9-2A-1E0.book 41 ページ 2010年2月17日 水曜日 午前10時42分