10
C Clamp the throttle cables to the
fuel tank rail, on the tank fitting by
use of this band. The front end of
the band must be directed down-
ward.
D Thread this clamp through the
upper hole in the gusset and se-
cure the two throttle cables. The
front end of the clamp must be di-
rected towards the inside of the
vehicle.
B Secure the carburetor heater
lead wire, the starter motor
cable, the negative (
–
) lead wire
of the battery, the A.C. generator
lead wire, the neutral lead wire,
the side stand switch lead wire,
the pickup lead wire, and the rear
stop switch lead wire (total 8
wires), to the fuel tank rail, near
the air cleaner intake port mount-
ing screw, by use of this band.
The front end of the band must
be directed towards the front of
the vehicle.
SPEC
CABLE ROUTING
E Bundle the #3 and #4 high-ten-
sion cords, on the head cover
mounting bolt at the #3 cord, by
use of this band.
F Do not entangle the lead wires
and the hosing.
Pass the bundle of lead wires
and that of hosing orderly as
shown.
G Pass the air cleaner drain hose,
the fuel tank drain hose, and the
fuel tank breather hose (total 3
hoses) through the guide wire of
the engine.
