Keyboard Stand Assembly
YDP-160/140
Owner’s Manual
36
2.
Attach B.
Depending on the model of digital piano you
purchased, the surface color of one side of B may
be different from the other side. In this case, posi-
tion B so that the side of the surface color similar
to D and E faces the player.
2-1
Place the lower side of B on each foot of D
and E, then attach the upper side to D and
E.
2-2
Attach the top of B to D and E by finger-
tightening the thin screws
3
(4
×
12mm).
2-3
While pushing the lower part of D and E
from outside, secure the bottom ends of B
using two tapping screws
4
(4
×
20mm).
2-4
Insert the other two tapping screws
4
(4
×
20mm) into the other two screw holes to
secure B.
2-5
Securely tighten the screws on the top of B
that were attached in Step 2-2.
3.
Securely tighten the screws on C
that were attached in Step 1-3.
4.
Mount A.
5.
Secure A.
5-1
Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2
Secure A by tightening the short screws
2
(6
×
16mm) from the front.
R
L
E
2-2, 2-5
2-4
2-3
2-3
2-1
D
B
Place the bot-
tom ends of the
rear panel on
each foot.
3
B
C
R
A
B
D
E
Be sure to place your hands at
least 10 cm from either end of the
main unit when positioning it.
At least
10 cm
CAUTION
•
Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
•
Do not hold the keyboard in any position other
than the position shown in the illustration.
5-2
A
5-1
Projection
of A
34
