10
12
. The signal light “blue” flashes when the remaining time becomes approximately 30 seconds.
13. Oil replacement finishes when the amount of new oil and that of wasted oil reach the value you set.
Stop idling the engine.
14. Check the level gauge, and make fine adjustments if the replaced oil is too much or too little.
Number of alternate replacement operations and waiting time varying depending on the amount of oil to be replaced
you set
Set value
Amount of oil to be
replaced at a time
Number of
replacements
Waiting time*
Total replacement time**
3 L
600 mL
5 times 10
seconds
Approximately 4 minutes
4 L
800 mL
5 times 10
seconds
Approximately 5 minutes
5 L or more 1000
mL
5 times (When you
set “5 L”)
15 seconds
Approximately 6 minutes and 30 seconds or more
* You can change the waiting time. See “P04: waiting time for alternate oil replacement” of Section “Settings” on page
16.
** These values are applicable when the temperature of new ATF is 20°C. (Use these values as the guideline only
because the replacement time varies depending on the oil type and the temperature condition.)
■
CVT mode
1. Connect the power cable to the AC outlet. (The buzzer sounds for one second.)
2. Press the POWER key.
3. Press the AUTO MODE key three times to select CVT mode.
4. Press the SET key.
Insert the nozzle into the level gauge hole securely.
When you hold down the SET key
(for approximately two seconds), the machine enters “Semi Auto mode.”
5. Insert the flexible nozzle into the level gauge hole.
6. Press the START key.
7.
Remove the wasted oil until the oil pan gets empty.
When the machine is in Semi-Auto mode
Digital display: “
セミオート
”appears on
the display.
Insert the nozzle into the level gauge
hole securely.
