11
An ASSA ABLOY Group brand
P/N AYRT-220-INST-FUL Rev A
Hex Screw
RH/RHR
LH/LHR
NOTE: For correct lever handing, the
hex set screw for the outside
lever shank must be installed
as shown (Fig. 8B).
Figure 8B
Figure 1C
A.
Once correct handing is determined
, remove the
clip that has held the hub in its correct position by
spreading clip ends to extract clip from shank as
shown in Figure 1C with detail.
Do not rotate cam from its original position.
("top" is marked RED)
2. Remove clip from shank.
3. Install hex set screw.
Install the Exterior Lever (Right Hand shown)
1. Install cylinder in exterior lever.
(If necessary, remove key from cylinder)
A. Drop cylinder in exterior lever handle as shown.
90°
B. Insert key in cylinder.
A. Place set screw in hole on side of
shank
toward edge of door
(opposite
lever handle); turn
CW
to
allow placement
of lever handle over shank.
Do not overtighten.
CW
Figure 1A
Figure 1B
Tailpiece
While supporting cylinder tailpiece (with finger);
rotate key 90°
clockwise (CW) to vertical position
(Figure 1B).
NOTE
: RH shown; with LH lever, rotate key 90°
counter-clockwise (CCW)
