23
• Home Omit and away entry sensors will be
ignored.
• If other sensors not set to Home Omit, Entry
or Away Entry are triggered, the alarm will be
activated immediately.
Stop the Alarm and Alarm
Display
During an alarm, the Control Panel and External
Siren will sound and dial the emergency phone
number.
Stopping the Alarm
1.
Press the disarm key and enter a user code on
the Control Panel or Key Pad. You can also tap
the contactless tag on the panel to disarm. The
Control Panel will sound a long beep and display
the device that caused the alarm. The External
Siren will beep twice and the strobe will flash side
to side.
• The Key Fob cannot stop an alarm caused by
burglar or emergency device.
2.
When the Control Panel is displaying the source
of the alarm, pressing any key will display
the telephone number that it dialled out and
acknowledged (if any). If there were more than 2
numbers that were acknowledged the numbers
will be shown by pressing further keys.
3.
When “Alarm off” is displayed the system is
disarmed.
Alarm Memory
• If an alarm was raised during your absence, and
the alarm sequence has been carried out, the
screen will continuously show “ALARM! ALARM!”.
• Disarm the system as normal.
1 To Clear Alarm Alarm Message
- Light panel up
- Press green/disarm icon
- Enter PIN #
- Press
3
repeatedly & quickly
- Alarm will double beep and say ‘Alarm Off’ when
reset.
Dialling & Call Acknowledgement
Auto Dialling
• If the system is in Away Arm mode, when an
alarm occurs the Control Panel will immediately
dial the preset phone numbers.
• If the system is in Home mode or Disarmed mode
when an audible alarm is initiated, the Control
Panel will wait for 15 seconds before dialling the
preset phone numbers.
• After dialling, the Control Panel will wait 5 seconds
then playback the messages in a loop. It will first
play the recorded address message then the
pre-recorded messages (Burglar, Emergency)
depending on the nature of the alarm and finally
an acknowledgement request message.
• The recipient should acknowledge the message by
pressing ‘9’ on their telephone when prompted.
• Recipients using radio DECT phones or mobiles
should press the numbers repeatedly until the call
is closed.
• If the Control Panel does not receive an
acknowledgement, the messages will be repeated
for a period of 80 seconds before attempting to
dial again. Each number will have 5 call attempts.
• The Control Panel will continue to dial the
number(s) until a call is successfully answered with
a ‘9’ acknowledgement.
• System auto-dialling features only operate under
tone-dialling method.
• When no telephone number is stored, the Control
Panel will not dial out.
Remote Access
The Control Panel allows you to control your system
remotely through the telephone line.
1.
Dial the phone number associated with the
Control Panel.
2.
Hang up on the first ring.
3.
Wait 5-10 seconds.
4.
Dial the number again.
5.
The Control Panel will answer the phone on the
first ring of that second call.
6.
Enter your PIN Code within 3 seconds - PIN Code
# 1 only.
7.
If the PIN code is correct, you will hear a long
beep. A list of different functions is detailed below:
Press 2
Put the system into Away Armed mode
(arm the system).
Press 3
Disarm the system.
Press 5
Checking the system status. Long single
beep for Away Armed, two beeps for Disarmed and
three beeps for Home Armed.
Press 7
Siren on.
Press 8
Siren off.
Press 9 or 0
Disconnect.
• Remember to press 9 or 0 before you hang up, or
the Control Panel will hang up automatically after
30 seconds.
23
