Learning in PIRs and Door/Window
contacts
To learn PIRs and door/windows contacts into
the system follow the steps below.
1
Enter 0000, then press TEST. the ‘Tx’ LED will
flash showing the keypad is in program mode.
2
Disable tamper by pressing TEST then 2. The
keypad will beep and the siren confirm.
3
Enter learn mode by pressing TEST then 4. The
keypad will beep and the siren confirm. The
PIRs and Door/window contracts can now be
learnt into the system.
4
Activate the learn/test button on each detector
in turn. The siren will beep as each detector is
learnt in.
5
Exit learn mode by pressing TEST then 5, the
keypad will beep and the siren confirm.
6
Exit programming mode by pressing OFF twice.
Mounting methods
Yale provide two methods of mounting. Choose
either the self adhesive pads or the screws and
wall plugs supplied.
Self adhesive installation
for door/window
contact
Clean the surface with a suitable degreaser.
Remove the protective covering from one side of
the double sided adhesive pad and firmly apply to
the back of the device. Next remove the other
cover and firmly press the item onto the desired
location.
• Do not use the adhesive pad method of
installation on a surface with peeling or cracked
paint, or on a rough surface.
Screw mounting
Remove the front of the device, and, if
necessary, break through the appropriate knockout
(where the plastic is thinner).
Using the holes as a template, drill holes in the
surface and insert the wall plugs if fixing into
plaster or brick.
Testing the radio performance
Before permanently installing detectors, check
that the siren will receive the system radio
transmissions by doing a simple radio range test.
1
Ensure that the system tamper is disabled.
2
Hold the detector in the desired location and
press the learnt/test button, siren should
respond with a single beep.
3
When you are satisfied that the detectors work
in your chosen locations, proceed with the
installation as described below.
• If the siren does not respond, the location may
be out of range, try alternative locations until
reliable radio contact is obtained.
Door/Window contacts
1
Ensure the system
tamper is disabled,
repeat steps to extend
the tamper disable
time a further hour if
necessary.
2
Ensure the jumper
switch is in the test
‘on’ position.
• In this position the
indicator light will
illuminate every time
the door contact is
operated.
3
Fit as described in
‘Mounting methods’,
mounting the detector
base on the frame and
aligning the magnet by the arrow as shown.
• The magnet should not be more than 8mm
from the detector when the door is closed.
• Ensure the tamper switch spring is positioned
so that it makes contact with the mounting
surface through the tamper switch aperture.
• If the door contact cannot be mounted on the
doorframe, use the HSA3090 multiple
door/window contact accessory kit with a
length of wire to mount the door contact
remotely (see below).
• When fitting to a window, fix the magnet to the
moving part and the detector to the frame.
4
Fix the detector on its base and secure with
screw. Test it by opening and closing the door
or window. The light will flash when an open
condition is detected.
5
Remove the detector, put the jumper switch in
the normal ‘off’ position. Screw the detector
back onto its base.
11
Jumper
switch
Door/
Window
Frame
Align
8mm (max)
Programming and mounting detectors
Before mounting detectors ensure that the system tamper is disabled as described
in section 4, point 1 (page 10).
5
Learn/
Test
button
PIR
Learn/
Test
button
Door contact
www.ukpanels.com