10
Mounting the siren and keypad
WARNING
Before mounting the keypad and siren ensure that the system tamper is
disabled as described below.
4
Disabling the system tamper
Before mounting it is important to disable the
tamper to avoid the siren sounding an alarm.
1
Enter 0000 then press TEST. The ‘Tx’ LED will
flash showing the keypad is in program mode.
2
Press TEST again, then 2. The keypad will beep
and the siren confirm. The system tamper is
now disabled. Activating the siren or keypad
tamper switches will not cause an alarm.
3
Exit the programming mode by pressing OFF
twice.
• The system tamper will remain disabled for 1
hour to allow you to mount the siren and
keypad. If more time is required, simply repeat
the steps above.
Mounting the siren
WARNING
The siren is
extremely loud!
The tamper switch
plunger protrudes
through the back of the
unit, so that if the siren
is pulled from the wall
the alarm is activated.
Ensure it is fully
depressed when the siren
is mounted. If there is a
gap, pack with a suitable
spacing material.
1
Having chosen your
location ensure that
the sytem tamper is
disabled, repeat the
steps to disable
tamper if necessary.
2
Using the large screws
provided, mount on
wall through the base
plate mounting holes
shown.
3
Fix the siren cover with the securing screw.
Mounting the keypad
1
Ensure system tamper is disabled. Repeat the
steps to disable the system tamper if
necessary.
2
Choose a suitable location, as described in
‘Location planning’ (usually next to main
entry/exit point).
3
On the rear plate of the keypad, break through
the four knockouts (where the plastic is
thinner).
4
Using the holes as a template, drill holes in the
surface and insert the wall plugs if fixing into
plaster or brick.
5
Attach the front of the keypad to the rear plate,
ensuring that the tamper switch closes. If the
tamper switch does not close it may be
necessary to pack out with a suitable spacing
material (keypad will beep every 30 seconds if
the tamper switch is not closed).
6
Re-insert and tighten screw.
Checking operation
Now that the siren and keypad are mounted
into position you can quickly check the operation
of the system by arming and disarming.
1
Enable the system tamper by entering 0000,
then TEST. ‘Tx’ LED will flash.
2
Press TEST again, then 3. System tamper will
now be active.
3
Press OFF twice.
4
Press 0000, then ARM. Siren should beep once
and flash LEDs. If siren beeps five times, the
siren tamper switch is not closed, to rectify the
problem, disable system tamper and ensure
that the switch closes.
5
Press 0000, then OFF. Siren should beep twice
and flash LEDs.
Tamper switch plunger
must be pressed in fully by
wall surface
Fixing holes x 4
www.ukpanels.com