Yale GC030VX, Руководство по обслуживанию

Страница: 48 / 64

Proc_Cal_015: Loaded Weight Calibration
WHEN TO PERFORM
1. Perform when the pressure transducer is re-
placed.
OR
2. Perform the calibration when the following proce-
dure does not pass.
Lift a load equal to approximately 3/4 the
lift truck capacity or more and raise the
load in the same manner as when perform-
ing the Proc_Cal_014: Load Weight Zero
Point several times to ensure the system
repeats within approximately ±2 percent of
truck capacity. If it does not, then remove
the load and recheck the Proc_Cal_014:
Load Weight Zero Point. If the load weights
are then within tolerance, continue using
the system. If not within tolerance, then
proceed to perform the Loaded Weight
Calibration.
CALIBRATION ORDER
1. Proc_Cal_001
2. Proc_Cal_015
WHY PERFORM
Because known load weights are not weighing within
±2 percent of truck capacity.
HOW TO PERFORM
WARNING
Keep yourself and all others clear of the lift mech-
anism. Never allow anyone under or on the forks.
Never put hands, arms, head, or legs through the
mast or near the carriage or lift chains. This warn-
ing applies not only to the operator but also the
helper. A helper must not be near the load or the
lift mechanism while the operator is attempting to
handle a load. The lift mechanism has moving
parts with close clearances that can cause seri-
ous injury.
Refer to Table 17 for the procedures on how to per-
form Proc_Cal_015: Loaded Weight Calibration.
Table 17. Proc_Cal_015: Loaded Weight Calibration
A. TYPICAL DISPLAY WITHOUT KEY, WITH OPTIONS
B. TYPICAL DISPLAY WITH KEY, WITHOUT OPTIONS
Proc_Cal_001: Service Password Entry before proceeding.
Action 1: Start Engine.
Action 2: Position Mast Vertical.
Action 3: With No Load, Activate Lift Control to Raise Forks/
Attachment Approximately 0.6 m (2 ft), But If Freelift Is Present,
Not More Than Maximum Freelift.
You Will See: Main Menu
Passwords
Proc_Cal_015: Loaded Weight Calibration 8000 YRM 1134
42 Confidential/Proprietary - Do Not Copy or Duplicate