An ASSA ABLOY Group brand
80-9470-0724-000 (02-13)
Caution : Strike Location Will Vary
Device Shim
See Page 1
Raised Molding
Clear Raised Door Molding
Use (1) Shim for each 1/8"
(3mm) of device lift needed.
Strike
Caution
- Strike location
will vary. Adjust strike to
compensate for the shim height.
Yoke Pin Shim Location
Yoke Pin Shim
60-7020-1064
Device Shim
See Page 1
Place under Yoke Pin. Use equal number as
device shim to match added thickness.
Figure 1.
DIM “A”
5/16" (8mm)
1/4" (6mm)
WIDE STILE
NARROW STILE
TRIM SERIES
Hold “A”
CAUTION:
When removing the spindle assembly from the trim,
keep the clutch spring and screws, they are needed for
reassembly. When finished, check the lock and unlock
function before mounting. Follow detail Figure 1 for
sizing the tailpiece to the door thickness.
For Thumbpiece Applications:
Thumbpiece applications follow the same procedure as
above, but the original smaller drive plate must be used
with the new tailpiece included in the kit. To do this
remove the cylinder housing assembly and the original
spindle assembly from the trim (steps 1 & 2 to left).
Remove the retaining ring from both spindle
assemblies, switch the tailpieces and reassemble
(longer tail-piece to the smaller drive plate) with a
retaining ring. Reattach to trim using clutch spring and
screws; then reassemble the cylinder housing with the
cylinder.
540F or 440F Trim Applications:
For 540F or 440F Trim remove roll pin from Tailpiece
assembly (keep pin), remove Tailpiece and replace with
optional Tailpiece supplied. Use initial roll pin to
reassemble. Size to fit, see Figure 1, above.
Strike
Caution
- Strike location will vary. Adjust strike to
compensate for the shim height.
Clear Raised Door Molding
Use (1) Shim for each 1/8" (3mm) of device lift needed.
Spindle Assembly
Spindle Assembly
60-7000-0217
Remove and replace
with 60-7000-0213
when required.
Cylinder Housing
Assembly
60-7000-0215
Must be disassembled
prior to removal of
spindle assembly.
Spindle Assembly
60-7000-0213
With longer Tailpiece
for RIM, SVR, and
CVR when required.
Trim Assembly
Tailpiece
2
Drive Plate
For Night Latch Function:
Replace Tailpiece as required
(Longer Tailpiece and Retainer Ring
provided) to maintain proper length
See Figure 1, above.
1
3
Device
Mounting
Surface
(See Note)
Cut Line
2
Product Support Tel 800.438.1951 • www.yalelocks.com
Yale® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group company. Other products' brand names may be trademarks or registered trademarks of their respective
owners and are mentioned for reference purposes only. These materials are protected under U.S. copyright laws. All contents current at time of publication.
Yale Security Inc. reserves the right to change availability of any item in this catalog, its design, construction, and/or its materials.
Copyright © 2001, 2013, Yale Security Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Yale Locks & Hardware is a division of Yale Security Inc., an ASSA ABLOY Group company.
