28-13-355-Rev4
8/10
BAR PLACEMENT
Carefully place Bar assembly onto vehicle.
Take care not to damage vehicle.
Slide Legs along Bar until foot clamp sits snug against vehicle rail.
Secure the Claw assembly to the vehicle rail using a 5 mm Allen Key or Torque
Wrench.
Torque to 4 Nm. Due to the geometry of the Everest flush rail, a small gap may
appear between clamp and rail. This is acceptable and has been tested.
Use a Tape Measure to ensure even Bar overhang on each side, re-adjust if
required.
Repeat process for remaining Bar.
11
=
=
CHECK BAR SLOT MEASUREMENTS
Using a Tape Measure, record Leg to underside slot
distance of each Bar in the table (right). Ensure
measurement is taken from the centre of the Legs
as shown. The ends of each bar should be the same
measurement respectively, if not, repeat Step 11.
BAR SLOT MEASUREMENTS
Front Bar (X)
Rear Bar (Y)
______mm x2
______mm x2
X
X = X
X
Y
Y = Y
Y
12
BAR SLOT COVERS
Cut Bar Slot Covers
as per measurements
recorded in the table
on Step 12 and push
into underside channel
of front and rear Bar
ends as shown.
NOTE
- Bar Slot Covers to be
inserted with flat side visible.
14
SECURE LEGS TO BARS
Given that the pivot assembly allows for
degrees of freedom, check all plates are evenly
arranged and bars are in the desired position/
angle before tightening M8 Hex Bolt to 7 Nm.
13