28-13-355-Rev4
6/10
CLAW ASSEMBLY
Insert an Unpinned Grip Plate into
each of the Clamp Claws from the
LockNLoad leg kit.
1
2
3
Push padded Claw Extrusions
into the Clamp Claws. (When
assembled onto a vehicle these will
click into position).
4
REMOVE LEG COVERS
Using the keys supplied in
the LockNLoad Leg Kit (sold
separately), remove all Leg Covers.
FOOT ASSEMBLY
Slide Rubber Foot Pads onto each
Foot Extrusion.
INSTALLATION OF LNL CROSSBARS
Slide Rubber Clamp Pads over each of the
Claw Extrusions.
Push padded Foot Extrusions into
the rear cavity of LockNLoad Legs.
(When assembled onto a vehicle
these will click into position).
5
6
LEG ASSEMBLY
Slide the Claw assembly into the
LockNLoad Leg, as shown.
Insert the M6 bolt and washer from
the Leg kit into the Leg and wind
(six revolutions) into the grip plate.
