28-13-004-Rev4
6/8
CHECK BAR LEGS ARE SECURE
Check all Bar Legs are secure.
19
SECURE LEGS TO BARS
Tighten all M8 Set Screws to
9 Nm using a 13 mm Spanner.
18
LEVEL BARS
With vehicle on a level surface,
adjust all Bar angles to be level
using a Spirit Level.
The Bar angle can be adjusted
to reduce any wind noise. In
most cases this is achieved by
getting the Bar in-line with air
flow parallel to the ground.
17
Air Flow
SECURE BARS TO PADS
From the LockNLoad Mounting kit,
assemble 1 x M6 Washer onto each
M6 set screw 30 mm as shown. Insert
through the centre hole on Leg into Pad.
15
Tighten all M6 set screws to 7
Nm using 10 mm Open Ended
Spanner.
Do not over tighten.
16
