1033034B-2/12
Remove cover from Landing Pad.
Attach Control Tower to Landing Pad
Close cover.
Use assembled towers and pads to
determine placement on vehicle.
CROSSBAR REQUIREMENTS:
The distance between the
Yakima crossbars is
determined by the accessories
you wish to carry.
Refer to the instructions for the
accessory to determine how
much crossbar spread your
accessories require.
Center punch
the holes.
Arrange Towers on car top from
front to back and side to side. Place
Towers considering the following:
• Design and strength
of
vehicle top.
• Compatibility of
accessories and crossbar
spread requirements.(See
side bar).
• Easy access to loaded
accessories.
• Start with 1/8”
pilot holes.
• Final hole size
should be 25/64”.
Do not drill through Landing Pads.
CAUTION:
DRILL HOLES 1/4” DEEP.
USE DRILL STOP OR
MASKING TAPE TO INSURE
ACCURACY!
HOLES SHOULD BE PRECISELY
ROUND AND FREE OF BURRS.
NOTE: CAREFULLY CHOOSE
LOCATIONS AVOIDING
BRACING, ELECTRICAL WIRING
OR OTHER OBSTRUCTIONS.
With the Control Tower cover
open, mark the outline of the
holes on the vehicle roof with
a #2 pencil.
Drill holes.
NOTE:
IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE
PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER SUCH AS A QUALIFIED
GARAGE OR AUTO BODY SHOP.
Use eye
protection!
