1033380C-4/15
TiGHTeN CarrierS TO MOUNTiNG HarDWare
SeCUre MOUNTiNG aSSeMBLY
OPeN Carrier
Make sure carriers are
vertically aligned.
• Slide carrier to expose
screw holes.
• Use hex wrench to
tighten screws.
LOaD SKiS Or
SNOWBOarDS
CLOSe CarrierS
WiTH FirM
PreSSUre
VeriFY THe CLOSUre!
• Pull upward on upper section of
carrier to see if the carrier can open.
• if it opens, apply more pressure
when closing the carrier.
ON SOME BARS
the mounting hardware
may sit at an angle.
*In some cases you may need to
close the mount between your
bindings. Position them fore/aft to
best avoid hatch contact.
• Keep the tips toward the
rear of the vehicle.
• Load bindings between
the carriers.*
