Yaesu ZCUT-3EX, Инструкция по эксплуатации

Страница: 9 / 12

9
設定例：100枚
SELECT
SELECT
SELECT
SELECT
SELECT
START
START
AUTO
MANU
You can preset the quantity of piece which will be cut out. (Maximum 999 pieces)
The machine will cut out the pieces based on your selected quantities then it
will stop.
■
Press the SELECT BUTTON and decide the length of tape.
■
Press the SELECT BUTTON more than few seconds to DISPLAY L-mode
setting screen. ( Factory default will indicate as “Lcon” )
■
Set the number of pieces to be cut out by using +/- BUTTON.
■
When you press the START BUTTON, DISPLAY indicates a signal shows
numbers backwards and cutting continuously.
・ When the DISPLAY indicates “0”, a buzzer sounds and the machine stops.
・ To stop the mahicne while running under L-MODE, press the START BUTTON.
L-MODE (Loop Mode)
The machine is able to be programmed.
A signal will be shown based on your selected quantity of pieces and it will
all cut out. (Maximum 999 pieces.)
A buzzer will has sound when the program is finished.
You can use the mode either MANUAL or AUTO.
■
Press the SELECT BUTTON, and choose the needed cutting length from
A to F with 4 digits.
■
Press the SELECT BUTTON more than few seconds to display L-mode
setting screen. ( Factory default will indicate as “Lcon” )
■
Press SELECT BUTTON again to display P-MODE setting screen.
・
Display will indicate as P with the selected cutting quantity of 1~999.
■
Use +/- BUTTON and set your needed number of quantity.
■
Choose AUTO or MANUAL by using AUTO/MANUAL BUTTON.
■
Press the START BUTTON, or lift the START SWITCH up and down.
The machine will feed-in and cut out a piece of tape on testing purpose.
・
To operate the machine by using MANUAL MODE, press the START BUTTON
or lift the START SWITCH up and down to feed-in the next piece of tape.
・
To operate the machine by using AUTO MODE, the machine will feed-in a
piece of tape automatically.
■
The signal shows numbers backwards when feeding-in another piece of tape.
■
When the DISPLAY indicates "0", the buzzer will has a sound.
・ The DISPLAY indicates the number of pieces that is preset.
Please wait until the buzzer stops.
・ If you take the tape out before the buzzer stops, the LED LAMP will flash.
Then you need to press the START SWITCH again.
■
If you try to change the mode (AUTO/MANUAL) when machine is operating,
just press AUTO/MANUAL BUTTON.
■
If you take out tape when the machine is operating with AUTO MODE and
the buzzer is sounding, another piece of tape will be fed after the buzzer.
At that time, indicating quantity on the display is one piece less than
setting quantity.
P-MODE (Preset Mode)
P-MODE
A
～
F
PRESS FOR 3SEC.
(exp.100pcs.)
(exp. A-100mm)
INDICATE CUTTING LENGTH
MANUAL MODE
AUTO MODE
INDICATE CUTTING LENGTH
(exp. A-100mm)
A
～
F
PRESS FOR 3SEC.
(exp.100pcs.)
L-MODE
4 digits
4 digits
or START SWITCH
or START SWITCH