Yaesu VX-8DR/E, Руководство по обслуживанию

Страница: 11 / 118

11 VX-8R/E and VX-8DR/E Technical Supplement
Alignment
CTCSS TX Deviation Adjustment (100.0Hz)
Ì
Connect the test equipment as shown in Figure 1: TX
Alignment Setup.
Ì
Rotate the DIAL knob to select the Alignment Menu
"100.0Hz".
Ì
Press the [
V/M
] button (the " " icon will appear on the
display).
Ì
Press the PTT switch to transmit without the micro-
phone input and rotate the DIAL knob so that the De-
viation Meter setting is 0.65 kHz (±0.05 kHz).
Ì
Release the PTT switch, and then press the [
V/M
] but-
ton (the " " icon will disappear on the display).
DCS TX Deviation Adjustment (DCS 023)
Ì
Connect the test equipment as shown in Figure 1: TX
Alignment Setup.
Ì
Rotate the DIAL knob to select the Alignment Menu
" DCS 023 ".
Ì
Press the [
V/M
] button (the " " icon will appear on the
display).
Ì
Press the PTT switch to transmit without the micro-
phone input and rotate the DIAL knob so that the De-
viation Meter setting is 0.65 kHz (±0.05 kHz).
Ì
Release the PTT switch, and then press the [
V/M
] but-
ton (the " " icon will disappear on the display).
A-Band 50 MHz Band Adjustment
Press the [
BAND
] key to select the 50 MHz Amateur
band.
Receiver Sensitivity Adjustment (TUNE DC)
Ì
Connect the test equipment as shown in Figure 2: RX
Alignment Setup.
Ì
Rotate the DIAL knob to select the Alignment Menu
" TUNE DC ".
Ì
Set the RF Signal Generator output to 52.100 MHz, at a
level of -10 dBµ, ±3.5 kHz deviation with a 1 kHz audio
tone.
Ì
Press the [
V/M
] button (the " " icon will appear on the
display).
Ì
Rotate the DIAL knob for maximum deflection on the
SINAD meter.
Ì
Press the [
V/M
] button (the " " icon will disappear on
the display).
Squelch Hysteresis Confirmation (HIS SQL)
Ì
Rotate the DIAL knob to select the Alignment Menu
" HIS SQL ".
Ì
Confirm that the alignment value is "0".
Squelch Threshold Adjustment (THLD SQL)
Ì
Connect the test equipment as shown in Figure 2: RX
Alignment Setup.
Ì
Rotate the DIAL knob to select the Alignment Menu
" THLD SQL ".
Ì
Set the RF Signal Generator output to 52.100 MHz, at a
level of -12 dBµ, ±3.5 kHz deviation with a 1 kHz audio
tone.
Ì
Press the [
V/M
] button (the " " icon will appear on the
display).
Ì
Press the [
F/W
] key two times to read the Squelch
Threshold level.
Ì
Press the [
V/M
] button (the " " icon will disappear on
the display).