Yaesu VX-170, Руководство пользователя

Страница: 23 / 88

VX-170 O
PERATING
M
ANUAL
21
R
EPEATER
O
PERATION
M
ANUAL
R
EPEATER
S
HIFT
A
CTIVATION
Checking the Repeater Uplink (Input) Frequency
It often is helpful to be able to check the uplink (input) frequency of a repeater, to see if the
calling station is within direct (“Simplex”) range.
To do this, just press the [ REV
(
HOME
)] key. You’ll notice
that the display has shifted to the repeater uplink frequency.
Press the [
REV
(
HOME
)] key again to cause operation to
revert to normal monitoring of the repeater downlink (out-
put) frequency. While you are listening on the input fre-
quency to the repeater using the [
REV
(
HOME
)] key, the
repeater offset icon will blink.
The configuration of this key may be set either to “RV” (for checking the input fre-
quency of a repeater), or “HM” (for instant switching to the “Home” channel for the
band you are operating on). To change the configuration of this key, use Set Mode Item
33: REV/HM. See page 77.
VFO S
PLIT
M
ODE
For working on repeaters with odd splits, or communicating with astronauts on orbiting
space vehicles, it may be necessary to use non-standard splits between the receive and
transmit frequency. If the application is infrequent enough not to warrant the dedication of
a memory channel for this purpose, the “VFO Split” mode may be used. Here is the proce-
dure for going Split:
1. Press the [ VFO
(
PRI
)] key, as needed, to select VFO-A. Set VFO-A for the desired
receiving (downlink) frequency (e.g.145.800 MHz).
2. Now press the [ VFO
(
PRI
)] key, and set VFO-B for the desired transmit (uplink) fre-
quency (e.g. 144.490 MHz).
3. Press the [ VFO
(
PRI
)] key once more to re-establish VFO-A as the “Main” (receive)
VFO.
4. Press the [
F
] key, then press the [
0
(
SET
)] key to enter the Set mode.
5. Rotate the DIAL to select Set Mode Item 50: VFO.SPL VFO.SPL VFO.SPL VFO.SPL VFO.SPL .
6. Press the [
F
] key, then rotate the
DIAL
to set this function “ VSP. VSP. VSP. VSP. VSP.
ON ON
ON ON
ON .”
7. Press the
PTT
switch once to save the new setting and exit to
normal operation.
8. You will now be operating in the Split mode. When you press
the PTT switch to transmit, you will observe that VFO-A and
VFO-B will reverse positions. The VFO selection indicator “ -b- ” will blink while the
transceiver is transmitting, this means that the VFO Split feature is now activated.