Yaesu VR-120D, Руководство по эксплуатации

Страница: 14 / 44

14 VR-120D O
PERATING
M
ANUAL
7. Press the [
V/M
] key while pressing the [
FUNC
] key. The
display will indicate "CLEAR" as a request for command
confirmation (see next step).
8. Now, press the [ V/M ] key while pressing the [ FUNC ] key
again; this action will delete the channel from the VFO Frequency Skip Memory, so as
to re-institute the frequency into the VFO Search scanning loop.
Pre-Programmed Frequency Search
The VR-120D allows you to program up to eight band segments within which VFO Search
scanning can be limited. This allows your radio's search to be concentrated on the most active
band segments in your local area, without wasting time in unused frequency segments.
To confine your search within one of the pre-programmed segments, you must first set
Menu #11 ("[SEARCH]") to the "LIMIT" option, per the following procedure:
1.
Press and hold in the [
FUNC
] key; while holding it in, press the [
SCAN
] key to
activate the "Set"(Menu) mode.
2. Rotate the DIAL knob to select Menu #11 [SEARCH].
3. Press and hold in the [
FUNC
] key; while holding it in, rotate the
DIAL
knob to select
"LIMIT" as the VFO Search mode.
4. Press and hold in the [ FUNC ] key; while holding it in, press the [ SCAN ] key to exit to
the VFO mode.
The
VR-120D
has been pre-programmed at the factory with default band limits. These are
grouped as "Search Band Memories" per the list below.
Basic Operation
Search Band
Memory #
Pre-Programmed
Frequency Range
Search Band
Memory #
Pre-Programmed
Frequency Range
L00 0.5200 ~ 1.8000 MHz L05 50.5000 ~ 54.0000 MHz
L01 1.8000 ~ 3.6000 MHz L06 88.0000 ~ 108.0000 MHz
L02 3.6000 ~ 10.5000 MHz L07 0.1000 ~ 1299.9950 MHz
L03 10.5000 ~ 21.0000 MHz
L- - *
0.1000 ~ 1299.9950 MHz
(Default)
L04 21.0000 ~ 30.0000 MHz
*: You can Customize this Pre-Programmed Frequency Range (see next Page)
Here is the procedure for initiating VFO Search Scanning within one of the above bands:
1.
Press the [ SCAN ] key; the radio will begin VFO Search Scanning (at this point, the
frequency range is unimportant).As soon as scanning begins, you will notice "L nn "
appearing in the upper left hand area of the display; this indicates that you are now
scanning within one of the band limits.
2. While VFO Search is active, press and hold in the [
FUNC
] key; while holding it in,
rotate the
DIAL
knob to select the Search Band Memory as shown above. The VFO
Search will now shift to the band segment within the Pre-Programmed Frequency Range
associated with that memory number.